no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+===== DMX adaptors. =====
+\\
+There are some differences in DMX connectors where some some fixtures comes with a 5 pin connector or some has a crossed polarity in the connector. (+ and – are swapped.)\\
+This has, among others, been a issue with some older Martin Fixtures. \\
+\\
+So here are some adaptors that may be a good idea to have in the tool box.
+\\
+\\
+\\
+**DMX 3 pin / 5 pin**\\
+\\
+There are types of DMX connectors. A 3 pin and a 5 pin.\\
+\\
+This gives a problem when the DMX controller and half of the fixtures are of the 3 pin type and the rest is the 5 pin type.\\
+\\
+To overcome this problem a 5 pin to 3 pin adaptor are needed.\\
+\\
+These comes in more shapes and can be bought from most of DMX light suppliers.\\
+Alternative it is quit simple to make and can be home made.\\
+\\
+The adaptors comes in more shapes and it is a question of like and don’t-like.\\
+\\
+Here is a cable type.\\
+\\
+{{:dmx_basics:3-to-5-pin-dmx-adapter_xl.jpg|}}\\
+\\
+\\
+Here is a solid type.\\
+Note that the solid type and the DMX cable connector in total gives a quit long load on the Fixture connector and this can give a high tension compared to the cable adaptor shown above. So if possible the cable type are to prefer.\\
+\\
+{{:dmx_basics:dmx_adapter_3m_5f.jpg|}}\\
+\\
+If it is a DIY project then here are the wiring diagram.\\
+{{:dmx_basics:dmx_5_to_pin_adapter.gif|}}\\
+\\
+\\
+**DMX Crossover adaptor.**\\
+It is just a cable where the one end of wire are swapped.\\
+{{:dmx_basics:dmx_x_adapter.gif|}}\\
+\\
+**DMX Terminator**\\
+This can be bought in various shapes or it can be DIY project.\\
+\\
+{{:dmx_basics:dmx-led-terminator-des-3l-1.jpg|}}\\
+{{:dmx_basics:dmx_terminator_el.jpg ?200|}}\\
+{{:dmx_basics:dmx_terminator.gif|}}\\
+\\
+\\
+----
+\\